Zippy MRW-6420P User Manual Page 1

PRODUCTS MANUAL MRT/MRW SERIES PS/2 Size Mini-Redundant Power Supply

　 INPUT CHARACTERISTICS: MRT-6300/6320P  VOLTAGE: 90 ~ 264 VAC FULL RANGE  FREQUENCY : 47 ~ 63 Hz  INPUT CURRENT: 6.0 / 3.0

　 INPUT CHARACTERISTICS: MRW-6350P/6400P/6420P  VOLTAGE: 90 ~ 264 VAC FULL RANGE  FREQUENCY : 47 ~ 63 Hz  INPUT CURRENT: 8.0 / 4.0

1.8 INSTALLATION & TESTING Turn off (Remote off) the on/off switch. Mount the power supply in the system chassis using the p

The individual LEDs (both on the rear side or on the front control panel) indicating the power supply’s status will not light. M

1.9 HOT SWAP PROCEDURES Please refer to the following when either power module or the fan found defective. A) Locate and turn

F) Turn on the power module. G) Check the LED of the power module that should light Green. H) Check the LED indicating the to

1.10 PINOUTS AND FUNCTION OF THE CONNECTORS *** Please be aware of the polarity*** THE LED CONNECTOR OF POWER#1 PIN# COLOR 1 GR

1. 11 TROUBLE SHOOTING If you have followed these directions correctly, there should be no problem occurred. Same common symptom

The “RELIABILITY “ solution to E-application 新巨企業股份有限公司 ZIPPY TECHNOLOGY CORP. POWER DIVISION HEADQUARTERS

INDEX 1.1 Introduction page 2~3 1.2 Packing page 3 1.3 Model Designation

1.1 INTRODUCTION First of all, thank you for purchasing MRT/MRW Series – PS/2 size Mini Redundant power supply. The MRT/MRW Ser

When all the power modules are at normal condition, it balances the load share through its parallel design and results in the in

1.4 FEATURES MRT/MRW Series --- Mini Redundant power supply (W/PFC). 1+1, Hot swappable, Hot pluggable, AC Input PSII Size,

1.5 PRE-INSTALLATION Before installing the MRT/MRW unit into the system chassis, please review the following drawing page and f